51 ?2011 littelfuse, inc. speci?cations are subject to change without notice. please refer to www.littelfuse.com/spa for current information. tvs diode arrays (spa ? family of products) revision: april 14, 2011 SP1011 series SP1011 general purpose esd protection - SP1011 series description applications zener diodes fabricated in a proprietary silicon avalanche technology protect each i/o pin to provide a high level of protection for electronic equipment that may experience destructive electrostatic discharges (esd). these robust diodes can safely absorb repetitive esd strikes above the maximum level speci?ed in the iec 61000-4-2 international standard ( level 4, 8kv contact discharge) without performance degradation. their very low loading capacitance also makes them ideal for protection high- speed signal pins. features t & 4 %
* & $
15kv contact, 30kv air t - j h i u o j o h
* & $
2a (t p =8/20s) t - p x d b q b d j u b o d f p g q ' (typ) per i/o @ 2.5v t - p x m f b l b h f d v s s f o u p g 1a (max) at 5v t 5 j o z v % ' / q b d l b h f (1.25mm x 1.0mm x 0.5mm) t & ' 5 q s p u f d u j p o iec61000-4-4, 40a (5/50ns) t - $ % 1 % 1 5 7 t % 7 % 1 m b z f s t % f t l u p q t 4 f u 5 p q # p y t . p c j m f 1 i p o f t / p u f c p p l t . 1 1 . 1 t % j h j u b m d b n f s b pinout i/o (1) gnd gnd i/o (4) i/o (2) i/o (3) udfn-6 (1.2 5 x1.0x0. 5 mm) functional block diagram 6 5 4 1 2 3 life support note: not intended for use in life support or life saving applications the products shown herein are not designed for use in life sustaining or life saving applications unless otherwise expressly indicated. rohs pb green application example shield ground SP1011-04utg outside world input keyboard controller d1 d2 d3 d4 signal ground SP1011 series 7pf 15kv unidirectional tvs array
?2011 littelfuse, inc. speci?cations are subject to change without notice. please refer to www.littelfuse.com/spa for current information. 52 tvs diode arrays (spa ? family of products) revision: april 14, 2011 SP1011 series general purpose esd protection - SP1011 series caution: stresses above those listed in absolute maximum ratings may cause permanent damage to the device. this is a stress o nly rating and operation of the device at these or any other conditions above those indicated in the operational sections of this speci?cation is not impli ed. absolute maximum ratings symbol parameter value units i pp peak pulse current (t p =8/20s) 2 a t op operating temperature -40 to 85 c t stor storage temperature -60 to 150 c thermal information parameter rating units storage temperature range -65 to 150 c maximum junction temperature 150 c maximum lead temperature (soldering 10s) 260 c electrical characteristics (t op =25 o c) parameter symbol test conditions min typ max units reverse voltage drop v r i r = 1ma 7.0 7.8 8.5 v reverse standoff voltage v rwm i r 1a 6 v reverse leakage current i leak v r = 5v 0.1 1 a clamp voltage 1 v c i pp =1a, t p =8/20s, fwd 8.7 v i pp =2a, t p =8/20s, fwd 10.2 v dynamic resistance r dyn (v c2 - v c1 ) / (i pp2 - i pp1 ) 1.5 esd withstand voltage 1 v esd iec61000-4-2 (contact discharge) 15 kv iec61000-4-2 (air discharge) 30 kv diode capacitance 1 c d reverse bias = 0v 12 15 pf reverse bias = 2.5v 7 pf note: 1. parameter is guaranteed by design and/or device characterization. capacitance vs. reverse bias 0.0 2.0 4.0 6.0 8.0 10.0 12.0 14.0 0.0 0. 5 1.0 1. 5 2.0 2. 5 3.0 3. 5 4.0 4. 5 5 .0 dc bias (v) capacitance (pf) insertion loss (s21) i/o to gnd -30 -2 5 -20 -1 5 -10 - 5 0 5 0 0 0 0 1 0 0 0 1 0 0 1 0 1 frequency (mhz) attenuation (db)
53 ?2011 littelfuse, inc. speci?cations are subject to change without notice. please refer to www.littelfuse.com/spa for current information. tvs diode arrays (spa ? family of products) revision: april 14, 2011 SP1011 series SP1011 general purpose esd protection - SP1011 series package dimensions udfn-6 (1.25x1.0x0.5mm) udfn-6 (1.25x1.0x0.5mm) symbol millimeters inches min max min max a 0.45 0.55 0.018 0.022 a1 0.00 0.05 0.000 0.002 a3 0.127 ref 0.005 ref b 0.15 0.25 0.006 0.010 d 1.20 1.30 0.047 0.051 d2 ---- e 0.95 1.05 0.037 0.041 e2 ---- e 0.4 ref 0.016 ref l 0.25 0.35 0.010 0.014 d e b 1 2 3 6 5 4 t op view pin 1 index area a a 1 2 3 5 4 6 l pin 1 chamfer 0.10 x 4 5 ? 0.0 5 c bottom view 0.0 5 c 0.0 5 c b a1 a3 c seating plane side view 0.10 c a m b 0.0 5 c m time temperature t p t l t s(max) t s(min) 25 t p t l t s time to peak temperature preheat p reheat ramp-up r amp-up ramp-down r amp-d o critical zone t l to t p c ritical zon e t l to t p re?ow condition pb C free assembly pre heat - temperature min (t s(min) ) 150c - temperature max (t s(max) ) 200c - time (min to max) (t s ) 60 C 180 secs average ramp up rate (liquidus) temp (t l ) to peak 3c/second max t s(max) to t l - ramp-up rate 3c/second max re?ow - temperature (t l ) (liquidus) 217c - temperature (t l ) 60 C 150 seconds peak temperature (t p ) 250 +0/-5 c time within 5c of actual peak temperature (t p ) 20 C 40 seconds ramp-down rate 6c/second max time 25c to peak temperature (t p ) 8 minutes max. do not exceed 260c soldering parameters
?2011 littelfuse, inc. speci?cations are subject to change without notice. please refer to www.littelfuse.com/spa for current information. 54 tvs diode arrays (spa ? family of products) revision: april 14, 2011 SP1011 series general purpose esd protection - SP1011 series embossed carrier tape & reel speci?cation udfn-6 (1.25x1.0x0.5mm) ordering information part number package marking min. order qty. SP1011-04utg udfn-6 (1.25x1.0x0.5mm) o4 3000 product characteristics lead plating pre-plated frame lead material copper alloy lead coplanarity 0.0004 inches (0.102mm) subsitute material silicon body material molded epoxy flammability ul94-v-0 notes : 1. all dimensions are in millimeters 2. dimensions include solder plating. 3. dimensions are exclusive of mold ?ash & metal burr. 4. all speci?cations comply to jedec spec mo-223 issue a 5. blo is facing up for mold and facing down for trim/form, i.e. reverse trim/form. 6. package surface matte ?nish vdi 11-13. part numbering system part marking system sp 1011 04 u t g series number of channels package u: udfn-6 t= tape & reel g= green C silicon protection array (spa tm ) family of tvs diode arrays o4 o 4 product series number of channels o = SP1011 k0 a0 b0 p2 d1 p0 t f e w d symbol millimeters inches min max min max e 1.65 1.85 0.06 0.07 f 3.45 3.55 0.14 0.14 d1 0.50 0.65 0.02 0.03 d 1.50 min 0.06 min p0 3.90 4.10 0.15 0.16 10p0 40.0 +/- 0.20 1.57 +/- 0.01 w 7.90 8.30 0.31 0.33 p2 1.95 2.05 0.08 0.08 a0 1.09 1.19 0.04 0.05 b0 1.42 1.52 0.06 0.06 k0 0.71 0.81 0.03 0.03 t 0.25 typ 0.01 typ
mouser electronics authorized distributor click to view pricing, inventory, delivery & lifecycle information: littelfuse: ? SP1011-04utg
|
